- Parkjet Plans
- F-20 Tigershark DC
F-20 Tigershark DC
F-20 Tigershark DC
Designed by DCobra
If you download plans and build the F-20, please consider sending the designer a donation for all of his hard work and inspiration!! PayPal welcomed!
Copy E-mail address then Click Here for PayPal
E-mail is dcobra_98@yahoo.com
Suggested Donation: $10.00
NOTE FROM DESIGNER
This Jet is Adapted from Jetset44's T-38 Talon Parkjet.
SUGGESTED PARTS: Bluecore FFF or 6mm Depron | .210 CF tube for wingspar | .157 CF tube for elevator torque tube | 3/16 aluminum tube for elevator rod pivots | 1/32 music wire for servo pushrods | 3/8 inch hardwood for motor mount | 1/32 lite ply (for centerline tank reinforcement) | 3M Satin tape | Glue (Probond/Gorilla Glue/Foamsafe CA/3M 77 spray adhesive or equivalent)
Optional parts (but strongly recommended) | (2)1/4 x 2-1/2" nylon bolts (centerline tank) | (2)1/4 nylon hex nuts (centerline tank) | (1) BT-60 Model rocket body tube (for centerline tank) | (2) PNC-60A Model rocket nosecones (for centerline tank)
The centerline tank is ***OPTIONAL*** but will greatly reduce wear and tear to the bottom of the aircraft and to the horizontal stabilator, as well as provide a hand grip for launching. Additional weight of the tank is 1.5 - 2 oz. After 50+ flights, I have yet to break a tip off the horizontal stabilator, and handlaunching is much easier as well.
BUILD THREAD
Designed by DCobra
If you download plans and build the F-20, please consider sending the designer a donation for all of his hard work and inspiration!! PayPal welcomed!
Copy E-mail address then Click Here for PayPal
E-mail is dcobra_98@yahoo.com
Suggested Donation: $10.00
NOTE FROM DESIGNER
This Jet is Adapted from Jetset44's T-38 Talon Parkjet.
SUGGESTED PARTS: Bluecore FFF or 6mm Depron | .210 CF tube for wingspar | .157 CF tube for elevator torque tube | 3/16 aluminum tube for elevator rod pivots | 1/32 music wire for servo pushrods | 3/8 inch hardwood for motor mount | 1/32 lite ply (for centerline tank reinforcement) | 3M Satin tape | Glue (Probond/Gorilla Glue/Foamsafe CA/3M 77 spray adhesive or equivalent)
Optional parts (but strongly recommended) | (2)1/4 x 2-1/2" nylon bolts (centerline tank) | (2)1/4 nylon hex nuts (centerline tank) | (1) BT-60 Model rocket body tube (for centerline tank) | (2) PNC-60A Model rocket nosecones (for centerline tank)
The centerline tank is ***OPTIONAL*** but will greatly reduce wear and tear to the bottom of the aircraft and to the horizontal stabilator, as well as provide a hand grip for launching. Additional weight of the tank is 1.5 - 2 oz. After 50+ flights, I have yet to break a tip off the horizontal stabilator, and handlaunching is much easier as well.
BUILD THREAD